These 3-way Weatherhead valves, with 1/4 female pipe ports feature a Delrin-spool design for smooth operation. Handle mounted on 1-1/4" long shaft. Not FAA approved. Model No. 6749 3-Port Valve - Flow is from either side to middle port. Model No. 6747 4-Port Valve - Flow is from any horizontal port to bottom port. |
I found it to be very stiff and was going to use a shaft to activate it, but returned it instead. If used with direct hand activation , then probably OK.
FUEL SHUT OFF VALVE P/N 6749
Excellent part, Excellent Shipping time...
This is the best fuel valve for a two tank system. Low cost and reliable. OFF, TANK1, TANK2, all in 180 degrees of movement. I bought this one to replace a 30 year old one in my Varieze.
Nice smooth operation and fit exactly like the original.
Be careful this is not a selector! The handle does not point in the direction of the fuel coming in ( left is left, up is right and right+down is off). I wont be using this one.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, this valve does not have a "both" position.
Yes, we pulled one from stock and looked at the inner valve as I turned the knob and if the center was the incoming fuel, you can direct the fuel from right, to left, then off at the center.
There is not a replacement seal available. You would have to purchase a new unit if your valve is no longer good.
The valves have female 1/4" NPT threads.
The shaft is 5/16".
Yes. It does click when the ports are lined up.
No, these do not have a "both" selection. It will be either left only, right only or off.
No there is not a labeled plate specifically available for this valve.