These fine quality switches are used in many aircraft. The switch housing is now machined from billet aluminum which makes this switch 25% lighter. They provide “ON” and “OFF” electrical control of both magnetos on single engine aircraft. The Key-operated switches mount from the rear of the panel in a 7/8” dia hole. Available with or without starter position. With Starter Position. Supplied w/switch plate two keys. (diode included) A-510-2 FAA PMA Approved. Made in USA |
Worked as advertised installation was quick and easy took 15 min to install 👍
IGNITION SWITCH A-510-2
Easy swap, quick delivery
IGNITION SWITCH A-510-2
Good quality product
IGNITION SWITCH A-510-2
OK
IGNITION SWITCH A-510-2
works great. looks good. screws a little short if you have more than one connector on connection such as ground.
IGNITION SWITCH A-510-2
happy
IGNITION SWITCH A-510-2
Great product. the order was processed quickly
IGNITION SWITCH A-510-2
Fast delivery by Aircraft Spruce, works as advertised. Like the new faceplate that comes with the switch but I didnt need it as my panel is still in great shape.
no comment
This order was satisfactory, not rescheduled like others.
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Please see the Documents tab of this web page. There is a link to the "Installation Diagram". This will provide all available terminal connection information for this ACS keyed ignition switch.
This switch (11-03170) is rated at 2 amps in a 12V system, or 1 amp in a 24V system.
Yes, there is a jumper cable included with P/N# 11-03170 switch.
Momentary "on" function on "start" (spring-return to "both"). Current through "BAT" & "S" terminals is 2 amps inductive at 12 volts or 1 amp inductive at 24 volts. Current through "L" and "R" magneto grounding circuits is less than 0.5 amps. Open circuit voltage is 300 volts.
The O.D. of the threads are approx. 7/8", but you will want to have a notch in the hole so the switch does not rotate. The drawing is in the documents tab.
1 year manufacturer's warranty.
This is 2.28" length and 2.23" at its widest point.
Approx .209 lbs.
In the left position the right mag is grounded and in the right position the left mag is grounded.
You will need a stud size #6 for the ring terminal to be used on Part # 11-03170.