Aircraft Spruce & Specialty Co.
Contact Us
Call Us
Sign In
- SHARE
Bose 6 Pin Lemo Headset Install Connector Kit
MFR Model# 323172-0010
- JUMP TO
- Overview
- Features
- Reviews
- Q&A
- View in Catalog
Overview
|
Custom panel connector and attached wiring harness for use with installed headsets. Semi-permanent installation provides aircraft power and audio to headset. Three-foot wiring harness allows for placement in locations throughout aircraft. Note: The headset install kit is FAA approved part of the A20 TSO. |
Features
- Self-latching, precision-designed, quick-connector wiring harness for panel mounting in aircraft with 10-32 volt DC systems
- Installation wire diagram and step-by-step instructions included
- Panel connector must be mounted by qualified avionics technician
Reviews
good deal
Verified Purchase
BOSE LEMO 6 PIN JACK INSTALL KIT
good product
Verified Purchase
BOSE LEMO 6 PIN JACK INSTALL KIT
Verified Purchase
BOSE LEMO 6 PIN JACK INSTALL KIT
The order went fine
Verified Purchase
BOSE LEMO 6 PIN JACK INSTALL KIT
Product was delivered on time, and in excellent condition.
excellent
Just what we needed and the cost was the best I could find. Item as advertised and pictured.
works well for a kit from bose
Nice harness with okay documentation. Color codes are potentially confusing on the shield wires, so study the diagram carefully before completing your connections. Note that there are two shielded pairs, and the shield wires are identical in appearance, so you need to ring them out to determine which is which.
I replaced the GA jacks connected to the intercom in my aircraft with these. Headsets instantly power up and no more worries about leaking batteries. Straight forward installation. It would be nice to have a wiring diagram showing the installation without the GA jacks cluttering the view but, then again, it isnt hard to ignore the jacks either.
Q&A
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This is the part you order if you want to put a LEMO panel power jack instead of installing mic/headphone jacks in the panel. You have to have a headset with the 6 pin LEMO plug for this to work without batteries in your headset.
This is for the installation of a 6 PIN Lemo power jack in the panel and is designed to work with any headset which is a 6 Pin Lemo Headset. The 6 PIN Lemo versions of the Bose X and A20 are supported.
The connector requires a panel hole that is 12.5mm (0.49") wide, by 14.0mm (0.55") tall.
The wiring for the harness is three foot long. A step by step wiring diagram is included with the install connector kit.
Yes, it is possible to have both jacks installed in the aircraft.
No, this does not charge a Tango battery kit.
Yes this will work with all Lemo style headsets.
