Description | Part Number |
---|---|
Insulated Flat Washer (SWC S1028) Tan | 04-00975 |
Insulated Flat Washers Insulated flat washer for headset. microphone jacks. P/N 04-00975 1/32" x 5/8" OD x 3/8" ID Insulated Shoulder Washers Insulated shoulder washer for headset/ microphone jacks. P/N 04-00976 .032/.032 x 5/8" OD x .387 ID x .437 ID/step |
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
SWITCHCRAFT INSULATED FLAT WASHER S1028
This is what you need to isolate your intercom jacks. get both the S1029 and S1028 as a set.
SWITCHCRAFT INSULATED FLAT WASHER S1028
AS described. As always great service
SWITCHCRAFT INSULATED FLAT WASHER S1028
Fit perfectly.
Fit and worked perfectly.
Solved my noise problem while transmitting insulate your Mike jacks
In order to avoid feedback problems (squealing), the Use of this Shoulder Washer is a must if you start using ANR headsets. (No part of the Panel Jacks should make contact with the ground). And... since they were on back order, Aircraft Spruce shipped them to me a few days later without charging me shipping ! Impressive customer service !
Product was delivered as requested .
Please note, Aircraft Spruce's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, you will use the shoulder washer (04-00976) behind the panel with the ridge facing towards the front of the panel. The flat washer (04-00975) goes in the front of the panel. No part of the jack should touch the panel.
Both the mic and headphone jacks should have insulating washers on both sides of the panel.
The dims are 1/32" x 5/8" OD x 3/8" ID.